- Joined
- Sep 23, 2010
- Messages
- 619
I am bored and its cold outside and i started this project 2 years ago and it was time to get it done. I welded up some 1" thick plate then made it square with my SBL shaper. I made it to make the roller bearing arms for SBL steadyrests easier since i don't have a mill or didn't at the time. The base has the same tapered round disc that the compound has and it bolts on the exact same way. I can mill an arm in just a few minutes with no guesswork because every thing is centered already. Just add a block of steel the end mill in my ER40 collet chuck and start cutting. I have used this fixture to cut out some complex alum shapes for the bike builder up the street i just clamped the alum to the fixture and started cutting. So here are a few pics. Enjoy...Bob
View attachment 102902
View attachment 102902
Last edited by a moderator: