jet 16

[thomas s]

Hello All,
I just got a Jet 16 mill drill can someone tell me how to hold the collet spindle to remove a end mill. Do they make a wrench to hold the spindle.

 

[GaryK]

Hello All,
I just got a Jet 16 mill drill can someone tell me how to hold the collet spindle to remove a end mill. Do they make a wrench to hold the spindle.

You can get THESE on eBay.

 

[thomas s]

Thank You, gkemper just what I was looking for

 

[mark883]

Or if you're cheap like me, UNPLUG, and hold on to belt while turning loose spindle screw.

Don't need to have it super-manly tight (at least I haven't run into that situation yet)

UNPLUG is important, if you do it this way. Or, wire in a slap-type kill switch.

(but, that tool sure is handy looking...)