- Joined
- Mar 25, 2013
- Messages
- 4,749
Upper pivot could look like this:
![1583590875298.png 1583590875298.png](https://www.hobby-machinist.com/data/attachments/273/273269-b8140ddc143782ace58723cc540453b8.jpg)
This would go into the top holes above. It is only 3/8 diameter. It would fit a 3/8 screw on the flats with a 3/16 guide that could have a C clip on the backside? Pivot is not super strong but should carry the load? My original thought was brass but maybe I will go with steel for strength.
Robert
![1583590875298.png 1583590875298.png](https://www.hobby-machinist.com/data/attachments/273/273269-b8140ddc143782ace58723cc540453b8.jpg)
This would go into the top holes above. It is only 3/8 diameter. It would fit a 3/8 screw on the flats with a 3/16 guide that could have a C clip on the backside? Pivot is not super strong but should carry the load? My original thought was brass but maybe I will go with steel for strength.
Robert