Yer, I have both the wizard and wizardE they are good but no real help with this machine. That's why I was hoping the Kipware T would work and yes I did the same thing I looked at all the youtube stuff, looked at the manual and swapped some emails with them but it hasn't really left me with a lot of confidence it will work for me or it's going to be that easy to lean on the run. It has been near imposable to find someone who really does use it contrary to what they say in their adds.
I was told even though my machine was new, it used real early Fanuc lathe G-code but I have not found which one. at this point, I either learn to hand-code it or try writing a post-processor for 360 or something.