- Joined
- Nov 21, 2010
- Messages
- 1,602
Cal I think this says it all
It was originally 2 phase ...
I can't believe I didn't even pay attention to this. Now would be the time for me to be led by the hand .
So can I buy a three phase size 0 starter and use all the other components or is this all an issue?
Also in post #33 I have a video on YouTube which shows you exactly why I need a repeated or to replace the contactor. I don't know how I would fix it and can it be used with three phase? I'm not sure what went to the T4A that's why I was confused but it looks like the D1 D2 and D3 originally went to the spindle motor . The original spindle motor is long gone and someone had replaced it with a single phase 220v and just had a plug to it . It seems that it was being used as a drill press only. The original Fairbanks Morris shaper motor is on the rear of the overarm and it is a 3 phase motor. The table feed is a Baldor 3 phase industrial motor which doesn't believe to be original either .
I have retrofitted a 1hp 3 phase Bridgeport pancake motor for the spindle btw .
So lay it too me ? Where do we go from here? Is this freaking rare or what?
Josh , origionally 2 phase ok I emailed you my info and just now I NOTICE YOUR plate wiring diagram K-148187 correct=thats what mine is??
whops disregard i was payin attention to the numbers yours is "M" 148187 mine is "K" 148187