Make Belt for SB9 Lathe

This was the best mod I did to my 9
9a8f7cb21bb69a8aa257d17b6aa86b1a.jpg
34f228e3aea657128d29613b9f3fd486.jpg
de44561bfd111cfb420c86b3b97f55a2.jpg


Sent from my SM-N975U using Tapatalk
 
Mark Winquist at Winky's Workshop on You Tube does a fantastic job making flat belts. Check him out.

 
Last edited:
Neil, I ended up fabricating mine out of leather as initially stated. Came out nicely, if I say so myself. Much easier to do than expected. I do like using the original leather type belt. Runs very nicely. I used artificial sinew tendon. Will see if it holds up. I am keeping an eye on it.
 
Best I think to not cut the belt' it is not that hard to disassemble the spindle and countershaft and install it in one piece.
 
You must log in or register to reply here.
Back
Top