Hi all, I am rebuilding one of my Black Diamond Drill Grinders for which I need a new or used 9/16" (ID) - 3C collet. The function of this collet is to "hold & clamp" the smaller collets for the different size drills which one sharpens.
The one I have is worn beyond use (the draw thread is kaput) and I know they were made at one time or another. So, a new or used source would be appreciated.
Also, and seperate from this question, I have about 3 pounds of "zinc" ingots and pieces of plate stock which need a "home". The plate stock was a sacrifical anod left over from my sail boat days. Free for the snail mail postage which will probably cost you three bucks or so for a small flat rate box.
E-mails are difficult for me to access at the present time but I can read replys to this post. Also, you can call me if you care to at (636)797-4203.
Thank you, Karl J. Schmitt of Hillsboro, MO
The one I have is worn beyond use (the draw thread is kaput) and I know they were made at one time or another. So, a new or used source would be appreciated.
Also, and seperate from this question, I have about 3 pounds of "zinc" ingots and pieces of plate stock which need a "home". The plate stock was a sacrifical anod left over from my sail boat days. Free for the snail mail postage which will probably cost you three bucks or so for a small flat rate box.
E-mails are difficult for me to access at the present time but I can read replys to this post. Also, you can call me if you care to at (636)797-4203.
Thank you, Karl J. Schmitt of Hillsboro, MO