- Joined
- Dec 28, 2015
- Messages
- 115
Photo from Tony's site (http://www.lathes.co.uk/leblond/) is below of a 25" lathe. Looks like dfletch is correct about the riser blocks. The bottom edge of "HEAVY DUTY" on the 25" lathe pictured below lines right up with the top of the bed. Looks like yours is setting higher to the bed. Looks like the back side head stock cover fits higher to the QCGB than in the picture below.
View attachment 118017
I see it now!
The reason the head stock looks lower than tail stock is th way is covering part of spacer.