- Joined
- Dec 12, 2011
- Messages
- 46
This topic has got to be one of the most discussed yet I'm still having problems. I apologize for bringing it up again.
The symptom is a concave surface on the cut-off piece. I mainly turn aluminum and haven't parted steel yet.
I shorten the tool to the minimum necessary.
I put the tool against the chuck and check for perpendicularity. I've even tried using a dial indicator to set the tool holder perpendicular.
ANy ideas?
The symptom is a concave surface on the cut-off piece. I mainly turn aluminum and haven't parted steel yet.
I shorten the tool to the minimum necessary.
I put the tool against the chuck and check for perpendicularity. I've even tried using a dial indicator to set the tool holder perpendicular.
ANy ideas?