- Joined
- Feb 24, 2015
- Messages
- 1,382
The tool holders bottom out on the compound slide. That's what keeps them from being able slide down low enough to line up with the center of your work.
You could have 50 thousandths ground off the bottom of each tool holder so it would hold the tool lower. Most people have multiple tool holders, so any time you get a new one, you'd have to modify it. The simple solution is to lower the surface the tool holder is bottoming out on.
You could have 50 thousandths ground off the bottom of each tool holder so it would hold the tool lower. Most people have multiple tool holders, so any time you get a new one, you'd have to modify it. The simple solution is to lower the surface the tool holder is bottoming out on.