- Joined
- Mar 25, 2015
- Messages
- 95
The power feed on my X axis is acting up. It works fine in rapid traverse but it's real slow in the regular mode. If I turn it all the way up to 9 it runs about as fast as it used to go on 3. It also kind of surges a little, like I'm messing with the speed dial.
I backed the gib all the way off and it didn't help, I also checked the gears and everything is meshing fine. I'm no electronics expert but it sounds like maybe the speed pot is dying... any ideas?
I backed the gib all the way off and it didn't help, I also checked the gears and everything is meshing fine. I'm no electronics expert but it sounds like maybe the speed pot is dying... any ideas?