- Joined
- Jan 11, 2013
- Messages
- 1,821
Ok Fellow Machine Geeks
If I can't post this here, I can't post it anywhere!
I included the geeky details below, but here is a pic I took of some chips I made tonight, finish boring some steel tonight! They are sitting on a 1/64 inch ruler:
![a8e4u6yz.jpg a8e4u6yz.jpg](https://www.hobby-machinist.com/data/attachments/119/119250-a4edbe5ef192f534affa4c290ed7e190.jpg)
I was putting a 5/8 in bore I piece of 1 inch steel, most likely 12L14, on my Heavy 10 in 5C collet. My feed was .0032, depth of cut was .004, 750 RPM. I was using an HSS boring bar pictures below:
I LOVE these Bokum Boring Bars!
![ezebytuq.jpg ezebytuq.jpg](https://www.hobby-machinist.com/data/attachments/119/119252-5301c3b368cfdfe6863baa04897e2c1f.jpg)
Bernie
South Bend 10L
![a8e4u6yz.jpg a8e4u6yz.jpg](https://www.hobby-machinist.com/data/attachments/119/119249-a4edbe5ef192f534affa4c290ed7e190.jpg)
![ezebytuq.jpg ezebytuq.jpg](https://www.hobby-machinist.com/data/attachments/119/119251-5301c3b368cfdfe6863baa04897e2c1f.jpg)
If I can't post this here, I can't post it anywhere!
I included the geeky details below, but here is a pic I took of some chips I made tonight, finish boring some steel tonight! They are sitting on a 1/64 inch ruler:
![a8e4u6yz.jpg a8e4u6yz.jpg](https://www.hobby-machinist.com/data/attachments/119/119250-a4edbe5ef192f534affa4c290ed7e190.jpg)
I was putting a 5/8 in bore I piece of 1 inch steel, most likely 12L14, on my Heavy 10 in 5C collet. My feed was .0032, depth of cut was .004, 750 RPM. I was using an HSS boring bar pictures below:
I LOVE these Bokum Boring Bars!
![ezebytuq.jpg ezebytuq.jpg](https://www.hobby-machinist.com/data/attachments/119/119252-5301c3b368cfdfe6863baa04897e2c1f.jpg)
Bernie
South Bend 10L
![a8e4u6yz.jpg a8e4u6yz.jpg](https://www.hobby-machinist.com/data/attachments/119/119249-a4edbe5ef192f534affa4c290ed7e190.jpg)
![ezebytuq.jpg ezebytuq.jpg](https://www.hobby-machinist.com/data/attachments/119/119251-5301c3b368cfdfe6863baa04897e2c1f.jpg)