Is there a preferred source for timing belts and sprockets for CNC conversions?
I can keep chips out with some simple shields, but keeping (water based) coolant out completely would be much harder.
Belts seem to be "poly", rubber/Kevlar, Neoprene, and a few other materials. At first glance it doesn't look like a bit of soluble oil would hurt any of them, but I figured it was better to ask than to jump in blindly...
I can keep chips out with some simple shields, but keeping (water based) coolant out completely would be much harder.
Belts seem to be "poly", rubber/Kevlar, Neoprene, and a few other materials. At first glance it doesn't look like a bit of soluble oil would hurt any of them, but I figured it was better to ask than to jump in blindly...