-
Welcome back Guest! Did you know you can mentor other members here at H-M? If not, please check out our Relaunch of Hobby Machinist Mentoring Program!
(Start Switch for Lathe) Electric changeover switch
- Thread starter Calandrod
- Start date
- Joined
- Jan 2, 2019
- Messages
- 7,115
Should be able to order one off Amazon.
If it still works good enough to get a multimeter on it you should be able to figure out the connections, otherwise @markba633csi will be along shortly to say exactly which one it is most likely.
John
If it still works good enough to get a multimeter on it you should be able to figure out the connections, otherwise @markba633csi will be along shortly to say exactly which one it is most likely.
John
- Joined
- Apr 30, 2015
- Messages
- 12,151
Are you running on 120 volts or 240?
For 120 volts the 16 terminal unit would be a better choice
These new switches may require a few extra jumper wires- I can show you
For 120 volts the 16 terminal unit would be a better choice
These new switches may require a few extra jumper wires- I can show you
Last edited:
120v. Why would the 16 terminal be better? I’m not savvy on electrical problems.
- Joined
- Apr 30, 2015
- Messages
- 12,151
Gives more flexibility. 16 terminals = 8 poles= 4 double pole switches and you often need all 4.
The original switch is a dedicated type which simplifies the OEM install. Costly even if you can find one.
New switches are more generic and require a few external jumpers to do the same function.
The original switch is a dedicated type which simplifies the OEM install. Costly even if you can find one.
New switches are more generic and require a few external jumpers to do the same function.
Last edited:
- Joined
- Apr 30, 2015
- Messages
- 12,151
When you get ready to install it start a new thread in the electrical section