- Joined
- May 24, 2012
- Messages
- 395
Since I had created this drawing, cannot wait to see it done.
The quality wasn't good but the layers movie looks cool: https://flic.kr/p/zMin27
Carcass with oil plug and bearing races pressed
Axle, initial cuts
My setup for finishing the axle. It was turned between MT 02 arbor and center
![20151017163737.JPG 20151017163737.JPG](https://www.hobby-machinist.com/data/attachments/69/69996-dad296fbf7b911a565fb42377f77cb9e.jpg)
![Sem título.png Sem título.png](https://www.hobby-machinist.com/data/attachments/69/69997-95abef1e2fd583a62105b7f8f060f4c4.jpg)
The quality wasn't good but the layers movie looks cool: https://flic.kr/p/zMin27
Carcass with oil plug and bearing races pressed
![20151017105045.JPG 20151017105045.JPG](https://www.hobby-machinist.com/data/attachments/69/69993-2531e5b30510b998d872e4a21749f8fb.jpg)
Axle, initial cuts
![20151017113913.JPG 20151017113913.JPG](https://www.hobby-machinist.com/data/attachments/69/69995-75d56a259d510284ab5a056e53861e29.jpg)
My setup for finishing the axle. It was turned between MT 02 arbor and center
![20151017163737.JPG 20151017163737.JPG](https://www.hobby-machinist.com/data/attachments/69/69996-dad296fbf7b911a565fb42377f77cb9e.jpg)