- Joined
- Sep 1, 2020
- Messages
- 549
Finally finished this Triple"B"S knife build. It did not turn out perfect, I made a mistake right near the end but great learning as always. Ton of learning with Fusion 360 and on my new Tormach 1100MX. In this video I tried engraving with my Tormach 1100MX and used a Personalizer Plus Electro Chemical Etching tool to put my logo on the blade, great marking tool if you have never used one. 42 pieces total in this knife, so honestly 1 mistake is disappointing but really so much else went right that I don't have much to complain about. The next one will be better.
Last edited: