- Joined
- Sep 3, 2011
- Messages
- 478
Hi Daryl,
That's a very interesting manual. Where did you find it?
Cal
That's a very interesting manual. Where did you find it?
Cal
I also found a diagram (no dimensions) for Van Norman Sub Head.
No measurements on anything.
But, I'm kinda wondering what it would take to build a Sub Head from scratch based on the diagram.
If I find enough over confidence, I wonder if anyone would like to collaborate on prints and the build.
Once a print with dimensions was agreed on, and tolerances established, it wouldn't matter who made which part. Collaborators could mail the parts.
To big of a wild scheme?
Daryl
MN
Daryl,
I'm not an expert on copyright, but it's my understanding that if the document was published before a certain date (IIRC some time in the 80's) AND it isn't marked as copyright, there's no problem. You can post portions of documents under "fair use" to further discussions, etc. Where you run into real problems is when you do something the deprives the owner of income from the copyright. Speaking generally, if there's nobody around to enforce a copyright by suing you, then you don't have too much to worry about. But again, that's just my understanding. Take the time to get yourself up to speed on copyright law, etc.
But, I look forward to seeing the docs!
I think that building a right angle attachment would be a very challenging project on many levels. (I bet you have lots of other projects where you time and money could be better spent.) The way my luck goes, if I undertook something like that, one would land in my lap when I was about 80% finished with my build...
Cal