I heard from Dutch who says his old Von wyck had a. 5mt stub taper
The 1.5 inch end measurement of the spindle could be the large end of 4.5mt or a 12 jarno, or the smaller end of a 5mt
I need advice on the best way to measure the inside of the spindle. I don't think I am doing this accurately enough
Sent from my iPhone using Tapatalk
The 1.5 inch end measurement of the spindle could be the large end of 4.5mt or a 12 jarno, or the smaller end of a 5mt
I need advice on the best way to measure the inside of the spindle. I don't think I am doing this accurately enough
Sent from my iPhone using Tapatalk