SO i just bought this old 1990 Enco Lathe...cool little lathe and it's in great shape but the switch is worn out. This is the closest switch I could find, without taking out a second mortgage and selling a pet or two but I cant figure out how to wire this thing, any one have experience with this?
Attached is the wiring diagram for the new switch, and a factory wiring diagram for the lathe with the old switch. I am not very familiar with switch diagrams, and, coming out of the motor is a total of 6 wires plus a ground, labeled 1-6. I think two pairs of the wires are a start and run circuit, but not sure about the other two, and they do not appear to be on the factory wiring diagram. There is also a capacitor (start i think) on one of the motor circuits. Any suggestions on how to wire this thing with out burning down my new shop?
Attached is the wiring diagram for the new switch, and a factory wiring diagram for the lathe with the old switch. I am not very familiar with switch diagrams, and, coming out of the motor is a total of 6 wires plus a ground, labeled 1-6. I think two pairs of the wires are a start and run circuit, but not sure about the other two, and they do not appear to be on the factory wiring diagram. There is also a capacitor (start i think) on one of the motor circuits. Any suggestions on how to wire this thing with out burning down my new shop?