Morning guys,well I started on the saddle of my Colchester lathe.Its just about all cleaned up,oil channels flush,all bolt holes have had a tap ran down them except one.Yep it was broken off by the last owner so don't blame me,yetLOL.Anyway its for one of the felt wippers (which I do need to find) and guys I just have never had any good luck trying to remove a broken screw.Its a 10/24 which is just about broken off flush,just a little tip sticking up.I was wondering what your method of removing a small broken screw is?Maybe this will increase my chances of being successful,asking first.Yes I know the pics are big which I have tried to make them smaller and at the bottom of the post but I haven't been successful at that neither.