[4]
[5]
[7]
Latest activity
[3]
-
sure ! I didn't spend much time at this, maybe an hour ...and I'm slow in my old age ! LOL and there may well be a better way to do... -
JimDawson reacted to benmychree's post in the thread quick and easy question about turning diamaters on the lathe for threading... with
Like.
Generally speaking, the major diameter should be the nominal size, in your example, it would be .625", but a small amount undersize is... -
JimDawson reacted to kev74's post in the thread quick and easy question about turning diamaters on the lathe for threading... with Like.
Look up the major and minor diameters for the thread you want to cut, then work from there. I like this site for looking up thread...
-
DDoubleeboy replied to the thread Wilton Bridgeport clone.Jet customer service is a mixed bag in my experience. The parts are usually expensive, and the support is minimal at best. Luckily...
-
Bbenmychree replied to the thread quick and easy question about turning diamaters on the lathe for threading....Generally speaking, the major diameter should be the nominal size, in your example, it would be .625", but a small amount undersize is...
-
Aanimal12 replied to the thread Another Treadmill Conversion.Fanman I think I'm bout ready to get started on this project , just wonderin how your motor & controller have been holdin up , still...
-
JimDawson reacted to grotto's post in the thread [How do I?] Attaching a permanent handle to a socket head with Like.
I use a ratchet on my drawbar. If I ever forget to take it off before switching the mill on (has happened once when I got distracted...
-
Today i had the day off work so after finishing couple of tasks in the morning i started on the little niva, i wanted to mount the wheel... -
I wanted to create a gear for a south bend (10L) collet closer hand lever attachment. It's a 40-tooth gear. I could use the small... -
It was a lot of fun and a learning experience. I am thinking of doing another one but with a very small bore and stroke to see if I can... -
JimDawson replied to the thread Tiny Parts.Ok continuing.... I got the parts done and shipped yesterday. All went well, but drilling & tapping the holes was a bit stressful...
-
-
Superburban replied to the thread [How do I?] Attaching a permanent handle to a socket head.I just use a stubby combination wrench. It stays nicely on the tool post, and is shorter then the handle for changing the holders. I... -
K$50 get $10 off. Must use American Express. Code AMEXSAVE
-
Kkev74 replied to the thread quick and easy question about turning diamaters on the lathe for threading....Look up the major and minor diameters for the thread you want to cut, then work from there. I like this site for looking up thread...
-
The above post pretty much covers it. Mine has a 1/3 HP, 120 Volt single phase, NEMA 56 frame Baldor brand, farm duty TEFC. (totally...
