A
Alan H.
Forum Guest
Register Today
I am sure that many here have used Evapo-Rust. I recently acquired some reamers that look as if they'd never seen a hole but they'd been stored in humid conditions and had some surface rust.
I decided to give them a dip in Evapo-Rust for a couple of hours and to see how it would work. I cleaned them up with brake parts cleaner and then dropped them in the bath.
Two hours soak time was more than enough to get them cleaned up. I then I rinsed them off with water per the instructions, dried them, and then hosed them down with Boeshield. They're in the tool chest now in their sleeves and should be protected.
I decided to give them a dip in Evapo-Rust for a couple of hours and to see how it would work. I cleaned them up with brake parts cleaner and then dropped them in the bath.
Two hours soak time was more than enough to get them cleaned up. I then I rinsed them off with water per the instructions, dried them, and then hosed them down with Boeshield. They're in the tool chest now in their sleeves and should be protected.