- Joined
- Jul 11, 2014
- Messages
- 496
Was line boring a hole through a tube for a project. Kept getting erroneous readings on the diameter. Near messed it up but believe I can still save it. Why did this happen I asked myself? I started to investigate and found the spindle of my RF-30 was moving .010 - .015. Creating a wobble keeping it out of true. Top seems solid but the bottom is cattywampus. Dang! Now I've got to remove the spindle and check the bearing. I've dismantled it before but admit prob'ly not as fequently as I should. The recommendation is to dismantle and lube about every 90 days.
So now several projects will need to be put on hold until I get it corrected. I believe its just the bearing but it waits to be revealed.
I guess I've not been paying attention to it's compaints so it decided to get my attention this way.
So now several projects will need to be put on hold until I get it corrected. I believe its just the bearing but it waits to be revealed.
I guess I've not been paying attention to it's compaints so it decided to get my attention this way.