- Joined
- Jun 23, 2019
- Messages
- 87
Is anyone running a 3 phase PM-1236T or PM- 935TS on a VFD? Do you leave the belt/speed setup in one position and use the VFD to control speed? (what setup) Or, do you set the VFD to 60 Hz and select the speed in the normal fashion? (I guess that option would be a little silly with a VFD)
I'm planning to connect my PM-1236T and PM- 935TS to one VFD for now (cause that's all I have) with a 3 position 3 phase switch. If the occasion arises where I need both machines at the same time I'll get another VFD.
That occasion may arises sooner than later because when the little woman ask what the lathe does I told her it peals potatoes, and the mill, it's a big mash potatoe mixer. I'm sure she will want to give it a go sometime.
I'm planning to connect my PM-1236T and PM- 935TS to one VFD for now (cause that's all I have) with a 3 position 3 phase switch. If the occasion arises where I need both machines at the same time I'll get another VFD.
That occasion may arises sooner than later because when the little woman ask what the lathe does I told her it peals potatoes, and the mill, it's a big mash potatoe mixer. I'm sure she will want to give it a go sometime.