Milling machine alignment

[Tr0nd]

Hello!

So as the topic says, I'm trying to adjust my milling machine, and the left/right (dare I say x axis) it was pretty easy.

But how do I adjust the Y axis on a machine like this?

 

[jwmelvin]

There doesn’t look to be an adjustable nod axis like on a Bridgeport. Perhaps shims between the white ram and the red head?

 

[Tr0nd]

Hey, thanks for answering! Yeah, I thought about that, but then I would be working on two axis at the same time. But I noticed these unbrako bolts right behind it, I might try loosen them and see how much bondo will fall out around that block The screw for the head tilt will stay if I do that, but it's not much needed. Guess it's time to order some shim stock.