An appliance dolly was used to move the lathe bed into the basement. The rest of the lathe components were hand carried.
Edit: added the chip tray weight and corrected the motor without pulley and the apron weights.
I have oil leaking out the apron where the feed shaft goes through. I don't see any kind of seal in the parts breakdown. Has anyone else had this issue?
I see where others with similar size chinese lathes have made upgraded 4 or 6 bolt compound clamps to improve rigidity. Has anyone else...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.