0XA QCTP DTI Mount?

[MaverickNH]

I’m looking to mount a 0-15-0 DTI (lever type, not plunger) in an 0XA QCTP But can’t seem to find such a tool holder.

I’d either buy one or 3D print one if anyone has a lead/link.

Thanks!

BRET

 

[Smithdoor]

Brown and Sharp makes a holder for that style that fit standard tool holder.
I have type of in a AXA holder and the same style of dial indicator.

Dave

 

[RickKr]

I've found magnetic base indicator holders to be extemely useful. I am particularly fond of Noga, like this one. Spendy but worth it, in my opinion. Mounts on my cross slide, compound or QCTP, depending on the need and doesn't take up an otherwise valuable QC toolholder.

 

[dml66]

I have a Shar's DTI kit which included a stem that fit nicely in an OXA holder. I never did figure out that the stem was for, but it worked just fine in this case. I can fish it out and take a picture of the setup if that would be helpful.

BTW, I second @RickKr on Noga, they are amazing holders.

 

[Smithdoor]

I have a Shar's DTI kit which included a stem that fit nicely in an OXA holder. I never did figure out that the stem was for, but it worked just fine in this case. I can fish it out and take a picture of the setup if that would be helpful.

BTW, I second @RickKr on Noga, they are amazing holders.

Most time I use a mag base.
My dial indicator came with bar mount for tool holders.

Dave

 

[Smithdoor]

Here set like mind
The bar goes into the tool holder.

Dave

 

[SouthernChap]

Here set like mind
The bar goes into the tool holder.

Dave
View attachment 471380

Ooooh...that's what that's for! Doh! I have the same thing in the cases for my vintage Mitutoyo and Verdict tenths DTIs.

Doh!