-
Welcome back Guest! Did you know you can mentor other members here at H-M? If not, please check out our Relaunch of Hobby Machinist Mentoring Program!
250-202 I.D. ???
- Thread starter jarhead
- Start date
- Joined
- Jan 2, 2019
- Messages
- 6,559
There’s been much discussion here about the Grizzly tool posts and holders.
Long story short different suppliers tool holders may or may not mate up, and you might have to modify some slightly to work with your Grizzly tool post.
It’s a BXA quick change tool holder, here’s the page from Shars with dimensions.
Most import tool holders and tool posts should work together, but they might not without a little modification. It’s not a precision piece so pretty inconsequential. If it holds your bits steady you’re good to go.
John
Long story short different suppliers tool holders may or may not mate up, and you might have to modify some slightly to work with your Grizzly tool post.
It’s a BXA quick change tool holder, here’s the page from Shars with dimensions.
Most import tool holders and tool posts should work together, but they might not without a little modification. It’s not a precision piece so pretty inconsequential. If it holds your bits steady you’re good to go.
John
- Joined
- Jan 7, 2016
- Messages
- 3,287
There are a number of threads on this site discussing issues with Grizzly tool posts and tool holders.
Here's a recent one. https://www.hobby-machinist.com/threads/shars-and-grizzly-grrr.106579/
Here's a recent one. https://www.hobby-machinist.com/threads/shars-and-grizzly-grrr.106579/