I don't know of a formal one, but the PM45 and PM32 are basically the same machine, so threads about them are applicable as well. Unless you are referring to the cnc machine. I have not seen him on the forum for some time, but darkzero has one as well as others here. Maybe they will chime in.
When I was wanting a larger bench mill than my PM25, I was 'seriously' looking at the 932 but balked at the Y-axis travel. If the 940 had been available at that time, I would have jumped all over it.
Yep, the Y travel on the 940, is why I purchased it, i've been pondering adapting a power feed to it after the wedding, because all that cranking gets laborious!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.