BXA Tool Holders

[BROCKWOOD]

Well Shars finally has these in stock again. At ~ $25.00 they are a bargain - but only good for 3/4".

Boring Turning and Facing Holder #2 Type 202 XL BXA

www.shars.com

 

[ArmyDoc]

Took some time to make, but not hard. I bought the dogpoints and wave washers off Amazon, the long set screws from McMaster. Made the knurled rings. Used gun blue to finish them. Finished when pandemic started, and used quite a bit since. Holding up well. All costs together, cost same or more to make vs buy.

You know the old adage, "Why should I buy that for $20 when I can make it for $25?" Or in my case for $50...

 

[Grandpop]

These are the XL 3/4 ones I bought on Amazon.

BXA #2XL OVERSIZE (3/4") QUICK CHANGE TURNING FACING BORING TOOL POST HOLDER: Amazon.com: Tools & Home Improvement

BXA #2XL OVERSIZE (3/4") QUICK CHANGE TURNING FACING BORING TOOL POST HOLDER: Amazon.com: Tools & Home Improvement

www.amazon.com

Had to clean out all of the threads/screws, but otherwise fine.

 

[Bob Korves]

If you want really nice hex drive screws that will take hard repetitive usage, try Holo-Krome:
https://www.holo-krome.com/ There are many sellers of them...

 

[Bob Korves]

(Duplicate post...)