Clausing kondia model G hobby partial restoration

[jester429]

my buddys bridgeport is wired the same way

 

[Jackle1312]

Here is my model G thats wired for 220 along with the schematic from the manual

 

[markba633csi]

Make some notes on how it's wired now- you'll thank yourself later
You could transfer the terminal block to another similar-sized (or slightly larger) die cast box
The original sure looks like a tight fit
-Mark

 

[jester429]

current progress. thank you guys for the help with the pictures and wiring diagrams!!! waiting for new SO cable to rewire supply lines. rotary phase coverter install is also underway. id like to replace those connecting plates. but they will have to do for now until i can find some clean ones.

 

[JimmyPmac]

Here is how my mill is wired. Like I said before, the wires aren't identified so I had to separate the 3 fields using an ohm meter, then arrange everything from there. My mill was wired for 480 when I got it. I basically had to pull everything off the studs separate the fields to identify the 3 phases and then hook up my power. I am far from an electrician, but thats how I did it. Got it right on the first try and no smoke!
Just to clarify, this is on a Clausing Kondia FV-1.
View attachment 353232View attachment 353233

I also have a Kondia G and have the same issue wired for 440v and need 240v do you have pictures of the 9 pin after the switch?

 

[JimmyPmac]

if its not toouch trouble i would love a picture of your connections. clausing csrries some but not all parts now but if they dont have them im told they would supply me with a print for the part so i coukd check it against bridgeport. the scematic i have doesnt show any part number for the motor or connection cover. what did you use as a replacement for the terminal box?

thank you!

Yes please I will need pictures as well I have so many questions for this box 440v to 240v is what I need.