- Joined
- Mar 19, 2011
- Messages
- 940
I just replaced the cross-slide and compound nuts on my 1978 10K. There is a LOT of drag (tight, loose, tight, loose) as I rotate the handles. I've tried loosening the nut retaining screws, and the gibs are properly adjusted. The only thing I can think of is that the screws are bent, and it wasn't a problem before, because the nuts were worn, as well.
Any other suggestions, before I pull it all apart, again?
Thanks,
Mike
Any other suggestions, before I pull it all apart, again?
Thanks,
Mike