Everede bit question

[Mike8623]

Got a general question. On the everede 1/4 bits for bars that use them the company lists the width as 1/4 inch then there are varying lengths. But anyone know how deep they are?

My question is are they all the same depth or do they vary. I have one that mics at .194 from top to bottom. Just wondering if they all are the same.

 

[twhite]

Got a general question. On the everede 1/4 bits for bars that use them the company lists the width as 1/4 inch then there are varying lengths. But anyone know how deep they are?

My question is are they all the same depth or do they vary. I have one that mics at .194 from top to bottom. Just wondering if they all are the same.

They are .216 deep for f you go to a sharp. As they have flats on the one edge. That is an unknown depending on how they make them. It is a good bet they are very consistent with what you measured. JMO


Cutting oil is my blood.

 

[Mike8623]

Thanks, getting ready to cut that channel on a 1" bar I just made....wanted to check before I mill out the area.

Anymore comments?

You guys have really been helping me lately and I'm learning.