Finished Up A Pin Spanner

[Nogoingback]

I recently bought a collet chuck for the Logan, and found that I needed some way of holding the chuck while tightening the collet nut, and wasn't willing
to lock the spindle with back gears to do it. So, I decided to fabricate a pin spanner to take advantage of a set of holes drilled in the face of the chuck.
Finished it up this morning by silver brazing the pins into the handle: got a little messy on the first one and had to file off some extra material, but it came
out fine and it fits the chuck nicely.

 

[Flyinfool]

Nice Job.

 

[Nogoingback]

Thanks!

 

[Chuck K]

Sure, you could buy one, but you wouldn't have the sense of satisfaction every time you picked it up to use it. Nice job!

 

[Nogoingback]

Thanks. I honestly never thought to measure the hole spacing and look for an off the shelf wrench.