- Joined
- Apr 30, 2015
- Messages
- 11,335
Just clocked my new (to me) Bison 3 jaw on my 12" Craftsman- getting nice runout numbers < 0.002"
granted I'm using a deep-dish socket as a test bar (Craftsman of course) but I'm pretty stoked.
I was prepared to take a skim cut on the backplate but with these numbers I don't think I need to. Looks fine as is. A turn-key purchase.
Mark
granted I'm using a deep-dish socket as a test bar (Craftsman of course) but I'm pretty stoked.
I was prepared to take a skim cut on the backplate but with these numbers I don't think I need to. Looks fine as is. A turn-key purchase.
Mark