Hi everyone,
I have a heidenhain digital readout and the y axis for some reason reads with the decimal in the wrong spot. X reads X0.0000, but Y reads Y0.00000 way too may zeros, but I for the life of me can't seem to figure out how to move that decimal point over. It is still set to inches, when I move the Y axis it would still read correctly if the decimal were in the correct spot. Any ideas are welocome
I have a heidenhain digital readout and the y axis for some reason reads with the decimal in the wrong spot. X reads X0.0000, but Y reads Y0.00000 way too may zeros, but I for the life of me can't seem to figure out how to move that decimal point over. It is still set to inches, when I move the Y axis it would still read correctly if the decimal were in the correct spot. Any ideas are welocome
