- Joined
- Jun 22, 2012
- Messages
- 1,552
Thanks for all the advice guys! The only reason I was talking about using shielded wire was because that's what the O.M. called for. I guess these vfd's are very sensative to voltage leaks etc. At least that's how I read it, but you guys are saying not to be to concerned with it. I will not be running the wires in a conduit as I may need to move the lathe from time to time. I was going to run a ground wire from the motor housing to the vfd ground termination point. I purchased a 4 pole twist lock plug set and I was going to use that for the motor power cable between the vfd and the motor. These vfd's have got to have the crappiest manuals and instructions I have ever seen, LOL.
Input wires, got it.
output wires, got it.
switch wires, got enough to figure it out I think, the switch diagram was a big help!
God help me when I try and wire a variable speed pot, LOL.
Oh well this is all new to me, I can wire a house no problem, but figuring out electronics.........still learning I guess.
Thanks to all for your help and patience with me on this important step.
Input wires, got it.
output wires, got it.
switch wires, got enough to figure it out I think, the switch diagram was a big help!
God help me when I try and wire a variable speed pot, LOL.
Oh well this is all new to me, I can wire a house no problem, but figuring out electronics.........still learning I guess.
Thanks to all for your help and patience with me on this important step.