- Joined
- Oct 16, 2017
- Messages
- 339
I have been blessed with additional time on my hands due to waiting for the Nigerian government to issue me a work visa. Next on the hit list was some sort of stop system for the mill vice. I have been constantly needing a work stop attachment for the vice. Abomb79 was showing (monetizing) an interesting work stop contraption that mounts to the T-slots in the table that looked sweet but I have time so why not "Getter Done"?
Raided the 1018 scrap pile. Probably did not need a right and left stop but hey, I may loose one. The 3/4" main rod has a flat to register on the rear of the vice.
I need to make (buy) some thumb screws for the stop slide. I did not have a mill long enough to square up the bottom of that slot.
The register pins may be a bit long. They are threaded 1/4-28.
Raided the 1018 scrap pile. Probably did not need a right and left stop but hey, I may loose one. The 3/4" main rod has a flat to register on the rear of the vice.
I need to make (buy) some thumb screws for the stop slide. I did not have a mill long enough to square up the bottom of that slot.
The register pins may be a bit long. They are threaded 1/4-28.