- Joined
- Feb 2, 2013
- Messages
- 3,627
I'm doing a carb swap on a honda CT90, but the new carburetor interferes with the valve cover.
i needed to make a spacer, i chose some scrap aluminum for the project
i marked of the general size, and freed it from its entanglement...
knocked the corners off with the 4x36 belt sander and smoothed it out...
here is a couple shots of the finished spacer next to the OEM isolator
i installed the spacer along with a couple hand made paper gaskets to complete the assembly!
Thanks for looking!
i needed to make a spacer, i chose some scrap aluminum for the project
i marked of the general size, and freed it from its entanglement...
knocked the corners off with the 4x36 belt sander and smoothed it out...
here is a couple shots of the finished spacer next to the OEM isolator
i installed the spacer along with a couple hand made paper gaskets to complete the assembly!
Thanks for looking!