Manual machining with a PM45 CNC mill

[cjtoombs]

So why send the handles, I do not get it.

Marketing.

 

[Ray C]

I took the handles off but left the disks on. It's very handy to move the table if the power is off. Sometimes I use the mill table and spindle to do critical measurements -no power or milling involved. Just a place to setup measurements.


Ray

 

[bloomingtonmike]

Forgive the thread sidetrack but I got my pendant installed tonight. You will love having one of these. ow it works great moving the table!! I nstalled its 20 pin port out of my monitor enclosure back.

Also one pic to show my solution for nmtb30 tool holding. Heavy Duty Red cart is from CraigsList and the top is holes cut in 3/4" oak plywood. Originally had only half the cart for toolholding but it was crowded so I did the second half tonight.

 

[zr8cnc]

nice setup!