O
ome
Forum Guest
Register Today
Hi Guys,
i have no idea how to begin to change a motor on a die filer to dc with speed control.
Besides the tubalcain video which i have watched many times.
I need step by step instructions or a video of the process.
I am a novice at this so;
shaft size of existing motor must be same shaft size of new motor.
Where do you place the motor so it uses the same pulleys.
I have researched thru the web, and only came up with bits and pieces. I cant even find any more than 4 pages of pictures with very little instructions. No mention of how much oil to put in.
There is no window to check level. Did they have good manuals with indormation, and not just brochure type that has only pictures and no real content?
Can anyone help this total in the dark newbie.
Thanks,
jon
i have no idea how to begin to change a motor on a die filer to dc with speed control.
Besides the tubalcain video which i have watched many times.
I need step by step instructions or a video of the process.
I am a novice at this so;
shaft size of existing motor must be same shaft size of new motor.
Where do you place the motor so it uses the same pulleys.
I have researched thru the web, and only came up with bits and pieces. I cant even find any more than 4 pages of pictures with very little instructions. No mention of how much oil to put in.
There is no window to check level. Did they have good manuals with indormation, and not just brochure type that has only pictures and no real content?
Can anyone help this total in the dark newbie.
Thanks,
jon