Thanks Ray. I have found all sorts of little things wrong with it but the one that concerns me most right now is the loose spindle followed by the tightness in the table moving it to the right. I knew I wasn't buying a BP or anything even close, but I have literally had to go thru this thing and tighten up every nut and bolt on it. I discovered the power feed not working today was due to a loose nut on the outside of the right table hand wheel. Tightened it up and works like a charm again. So now if I can fix the other two issues I'll be all set until I decide to go into it deeper. I am also somewhat disappointed in the lack of concern with my two contacts with Tech Service. The only thing the guy did today was pull out an owners manual and read it to me regarding the power feed. I told him I had already read the manual and it didn't say squat about my specific issue. All he did was basically tell me to call back. Oh well.........
Rick
Rick