NT40 to 2" weldon

T

tazzat

Ad Blocker
Registered
Joined
Jun 26, 2019
Messages
92
Got a boringhead (NMTB40) that i need to use in a portable drill that have a 2" weldon..
It there an adpter or do i need to make one?
 
Can the arbor be changed on the boringhead? That would be easier and take up less room than an adaptor. Just curious,how does one hold into a portable drill with a boring head on it.
 
Arbor is fixed..
This drill
normaco-tools.com

Portable Drill

Portable Drill is a tool for heavy-duty drilling, used especially in the offshore industry for boring and stud removal.
normaco-tools.com normaco-tools.com
 
That makes sense. I had visions of a hand held drill. I would find a different boring head. By the time an adaptor is made the new bar would have been cheap in comparison. Would also be concerned with the loose of z travel.
 
The boringhead i got is a Wohlhaupter UPA4.
Made a adapter,did not add any lenght to the head..

Drive dogs is smale but for a boringhead it is no problem i think
IMG_20200409_142744.jpg.
Now i need to test this..after easter.
.IMG_20200409_142827.jpg
 
Last edited:
You must log in or register to reply here.
Back
Top