- Joined
- Mar 13, 2014
- Messages
- 46
Hi guys,
this is my first actual post (bar the introduction).
I am trying to get the best out of my small 10" italian lathe (PAV) and am after an AXA QCTP. Aloris, Dorian and the fancy swiss option are out of the question, but I think the Phase II alternative will work just fine.
My problem is that I have found no European supplier for the Phase II qctp and shipping from the US is too expensive (if the seller will ship at all...).
Any help from the guys of this side of the Atlantic?
Thanks in advance,
Thanos
this is my first actual post (bar the introduction).
I am trying to get the best out of my small 10" italian lathe (PAV) and am after an AXA QCTP. Aloris, Dorian and the fancy swiss option are out of the question, but I think the Phase II alternative will work just fine.
My problem is that I have found no European supplier for the Phase II qctp and shipping from the US is too expensive (if the seller will ship at all...).
Any help from the guys of this side of the Atlantic?
Thanks in advance,
Thanos