Small Tool Gloat

[bcall2043]

Stopped by the junk yard today looking for some clean flat stock for a project and found a small tool that I was not looking for but I had to adopt it anyway. It is a small 3 x 5 inch machinist square. I have not checked it out yet and it has a little rust but should do for most of the smaller needs. I can keep the good one in the tool box and free of fingerprints. If it proves to have something wrong with it then it is only about 13 cents (by weight/scrap cost) lost. I love junk yards!


I also found the flat stock that I needed for the project. It’s been a good day!

Benny
The Orphanage Never Closes

 

[Old Iron]

Benny you guys just have it made up there. Nice find however tools are to be used not to leave in the tool box so know finger prints get on them.....:roflaul