- Joined
- May 22, 2019
- Messages
- 89
Does anyone see me running into problems if I were to make a tool post grinder with a 1.5kv er20 spindle motor 220v 3 phase? I have a vfd and 1.5kv -2hp should be more than enough hp for any wheel or at least bigger than practical on my machine, and it would take up much less room.
I was going totry a servo motor but since I have a vfd already the spindle motor seems to be the best route for me but I have zero experience with spindle integrated motors
I was going totry a servo motor but since I have a vfd already the spindle motor seems to be the best route for me but I have zero experience with spindle integrated motors