One of the current projects is repairing back hoe attachment for bobcat.
After all new hoses we are testing unit and seal goes out on a ram.
So we need a pin spanner to hook the end cap that is 4 inches.
Looked around the yard for something to start and found a little chunk of 3/8 plate that could be used.
No gas for torch so what to do...
Grab the end in the Kurt and use a hole saw.
It only is about 1/2 circle but that is what we needed.
Slowest it can go in back gear and it came out good, about 1/8 inch too big but it should work.
Need to drill hole for pin and maybe a square hole for breaker bar.
Sent from my SAMSUNG-SM-G930A using Tapatalk
After all new hoses we are testing unit and seal goes out on a ram.
So we need a pin spanner to hook the end cap that is 4 inches.
Looked around the yard for something to start and found a little chunk of 3/8 plate that could be used.
No gas for torch so what to do...
Grab the end in the Kurt and use a hole saw.
It only is about 1/2 circle but that is what we needed.
Slowest it can go in back gear and it came out good, about 1/8 inch too big but it should work.
Need to drill hole for pin and maybe a square hole for breaker bar.
Sent from my SAMSUNG-SM-G930A using Tapatalk