I had put witness marks when I removed the bearing cap. If you did make sure to line them up.
Tighten the 3 cap screws down and you've installed the bearing cap. Next!
Another view of where you install the bearing cap screws.
Install the 3 cap head scres like so. The other three holes in the cap are used for removing a stuck cap.
I had put witness marks when I removed the bearing cap. If you did make sure to line them up.
Place the bearing cap over the bearing and the wavy spring washer.
Set the wavy spring washer on top of the bearing.
Side view of wavy spring washer...new wavy spring washer.
expressline99

I had put witness marks when I removed the bearing cap. If you did make sure to line them up.

As you disassemble any of these things put marks with a punch or with a marker so you can put things in the same orientation when replaced. It this case probably won't matter but I did it anyway. It's good practice.
Click to expand...

Media information

Album
Bridgeport Series 1 VS 2hp reinstalling lower/upper belt housing on the head
Added by
expressline99
Date added
View count
1,079
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Device
NIKON COOLPIX S560
Aperture
ƒ/5.6
Focal length
6.3 mm
Exposure time
1/60 second(s)
ISO
200
Flash
Auto, fired
Filename
DSCN5747.JPG
File size
2.1 MB
Date taken
Sat, 20 May 2017 7:53 PM
Dimensions
3648px x 2736px

Share this media

Back
Top