Install the bearing spacer ring. It just slides into place. At this point you want to check and make sure the brake bearing cap spins without binding.
Press the spindle pulley hub into the stationary vari-disc pulley.
The spindle pulley hub key is square.
Time to install the key into the spindle pulley hub. (note this is spindle pulley hub that was broken in my original post.) This one is brand new.
Install the bearing spacer ring. It just slides into place. At this point you want to check and make sure the brake bearing cap spins without binding.
Bearing spacer ring that goes on the brake bearing cap after the cap has been installed.
Press the brake bearing cap into place on the stationary vari-disc pulley. Press only on the INNER race of the bearing this time!
Make sure the bearing is completely flush in the brake bearing cap.
expressline99

Install the bearing spacer ring. It just slides into place. At this point you want to check and make sure the brake bearing cap spins without binding.

Media information

Album
Bridgeport Series 1 VS 2hp belt housing tear down and rebuild
Added by
expressline99
Date added
View count
457
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Device
NIKON COOLPIX S560
Aperture
ƒ/5.6
Focal length
6.3 mm
Exposure time
1/60 second(s)
ISO
200
Flash
Auto, fired
Filename
DSCN5558.JPG
File size
2.1 MB
Date taken
Fri, 14 April 2017 8:09 PM
Dimensions
3648px x 2736px

Share this media

Back
Top