Lightly lube the brake lever sleeve and install it. This was the new one...after seeing the picture I removed it and buffed out the light rust...
Brake operating finger pivot stud with the brake operating fingers installed... my pivot stud had to be ground a touch to install it easily.
Install the set screw to hold the brake lever sleeve in place.
Install the set screw to hold the brake lever sleeve in place.
Lightly lube the brake lever sleeve and install it. This was the new one...after seeing the picture I removed it and buffed out the light rust...
Press the bearing in until it is completely seated. Like shown in this picture.
The bearing I used for the adjustable vari-disc.
Bearing numbers I used (2 of 2 sets of numbers on the bearing)
expressline99

Lightly lube the brake lever sleeve and install it. This was the new one...after seeing the picture I removed it and buffed out the light rust...

Media information

Album
Bridgeport Series 1 VS 2hp belt housing tear down and rebuild
Added by
expressline99
Date added
View count
427
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Device
NIKON COOLPIX S560
Aperture
ƒ/5.6
Focal length
6.3 mm
Exposure time
1/60 second(s)
ISO
200
Flash
Auto, fired
Filename
DSCN5505.JPG
File size
2.1 MB
Date taken
Thu, 13 April 2017 6:59 PM
Dimensions
3648px x 2736px

Share this media

Back
Top